Chapter 16 System
PMG5318-B20A User’s Guide
140
16.4 SLID
To change your GPON Device’s Subscriber Location ID (SLID) setting, click Maintenance >
System > SLID. The screen appears as shown.
Figure 74 System > SLID
The following table describes the fields in this screen.
Table 55 System > SLID
LABEL DESCRIPTION
Enable SLID Select this to enable use of SLID.
SLID Value Enter the SLID used for gaining access to the service provider’s network.
Apply Click Apply to save your changes back to the GPON Device.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
