Chapter 9 Voice
PMG5318-B20A User’s Guide
90
9.4 Analog Phone
Use this screen to link the GPON Device’s analog phone ports with one or more SIP accounts to
handle outgoing and incoming calls. Click VoIP > Phone. The following screen displays.
Figure 47 VoIP > Phone > Analog Phone
Each field is described in the following table.
9.5 Speed Dial
Speed dial provides shortcuts for dialing frequently used (VoIP) phone numbers. You also have to
create speed-dial entries if you want to call SIP numbers that contain letters. Once you have
configured a speed dial rule, you can use a shortcut (the speed dial number, #01 for example) on
your phone's keypad to call the phone number.
Table 32 VoIP > Phone > Analog Phone
LABEL DESCRIPTION
Phone Port Selection
Phone Port
Selection
Select a phone port to configure on this screen.
Phone to SIP Account
SIP Account This indicates the SIP account mapping to the phone port for both incoming and
outgoing calls. Select None to disable the phone port so you cannot receive and make
calls through the phone port.
SIP Number This indicates the SIP account’s number. You can click it to open the SIP Account
screen, where you can change it.
Service Provider This indicates the service provider used by this SIP account.
SIP Account
Status
This indicates whether the account is active or not. Click it to open the SIP Account
screen, where you can change the status.
Apply
Click this to save your changes.
Cancel Click this to exit the screen without saving any changes.
To Next Page
Loading...
