ZyXEL Communications PMG5318-B20A - No Security; WEP Encryption

Chapter 6 Wireless LAN
PMG5318-B20A User’s Guide
48
6.3.1 No Security
In the Network > Wireless LAN > Security screen, select No Security from the Security Mode
list to allow wireless devices to communicate with the GPON Device without any data encryption or
authentication.
Note: If you do not enable any wireless security on your GPON Device, your network is
accessible to any wireless networking device that is within range.
Figure 20 Network > Wireless LAN > Security: No Security
The following table describes the labels in this screen.
6.3.2 WEP Encryption
Use this screen to configure and enable WEP encryption. Click Network > Wireless LAN >
Security to display the Security screen. Select Static WEP from the Security Mode list.
Table 14 Network > Wireless LAN > Security: No Security
LABEL DESCRIPTION
SSID Select Select the SSID for which you are configuring security settings.
Security Mode Choose No Security from the drop-down list box.