Chapter 13 Static Route
PMG5318-B20A User’s Guide
121
13.2.2 Static Route Edit
Select a static route index number and click Edit. The screen shown next appears. Use this screen
to configure the required information for a static route.
Figure 64 Static Route Edit
The following table describes the labels in this screen.
Apply Click this to apply your changes to the GPON Device.
Cancel Click this to return to the previously saved configuration.
Table 45 Static Route (continued)
LABEL DESCRIPTION
Table 46 Static Route Edit
LABEL DESCRIPTION
Active This field allows you to activate/deactivate this static route.
Route Name Enter the name of the IP static route. Leave this field blank to delete this static route.
Destination IP
Address
This parameter specifies the IP network address of the final destination. Routing is always
based on network number. If you need to specify a route to a single host, use a subnet
mask of 255.255.255.255 in the subnet mask field to force the network number to be
identical to the host ID.
IP Subnet Mask Enter the IP subnet mask here.
Gateway IP
Address
Enter the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward packets to
their destinations.
Back Click Back to return to the previous screen without saving.
Apply Click Apply to save your changes back to the GPON Device.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
