ZyXEL Communications PMG5318-B20A - The Reset Button; Using the Reset Button

Chapter 1 Introduction
PMG5318-B20A User’s Guide
12
Refer to Section 1.5 on page 11 for information on hardware connections.
1.6 The Reset Button
If you forget your password or cannot access the web configurator, you will need to use the RESET
button at the back of the device to reload the factory-default configuration file. This means that you
will lose all configurations that you had previously and the password will be reset to the default.
1.6.1 Using the Reset Button
1 Make sure the POWER LED is on (not blinking).
INTERNET Green On The GPON Device has an IP connection but no traffic.
Blinking The GPON Device is sending or receiving IP traffic.
Off The GPON Device attempted to make an IP connection but failed.
Red On The GPON Device does not have an IP connection.
LAN 1~4 Green On The GPON Device has a 1G Ethernet connection with another device
(such as a computer) on the Local Area Network (LAN) through this
port.
Blinking The GPON Device is sending/receiving data to/from the LAN through
this port.
Orange On The GPON Device has a 10/100M Ethernet connection with another
device (such as a computer) on the Local Area Network (LAN) through
this port.
Blinking The GPON Device is sending/receiving data to/from the LAN through
this port.
Off The GPON Device does not have an Ethernet connection with the LAN
through this port.
WLAN Green On The wireless network is activated.
Blinking The GPON Device is communicating with other wireless clients.
Off The wireless network is not activated.
Orange Blinking The GPON Device is setting up a WPS connection.
PHONE 1~2 Green On A SIP account is registered for the phone port.
Blinking A telephone connected to the phone port has its receiver off the hook or
there is an incoming call.
Off The phone port does not have a SIP account registered.
Red On SIP account registration failed.
USB 1~2 Green On The GPON Device recognizes a USB connection through the USB slot.
Blinking
The GPON Device is sending or receiving data to or from the USB device
connected to it.
Off The GPON Device does not detect a USB connection through the USB
slot.
Table 1 LED Descriptions
LED COLOR STATUS DESCRIPTION