ZyXEL Communications UAG4100 - Object References

Chapter 10 Interfaces
UAG4100 User’s Guide
123
10.3.2 Object References
When a configuration screen includes an Object Reference icon, select a configuration object and
click Object Reference to open the Object Reference screen. This screen displays which
configuration settings reference the selected object. The fields shown vary with the type of object.
Figure 78 Object References
Add Click this to create a new entry.
Edit Select an entry and click this to be able to modify it.
Remove Select an entry and click this to delete it.
# This field is a sequential value, and it is not associated with a specific entry.
IP Address Enter the IP address to assign to a device with this entry’s MAC address.
MAC Enter the MAC address to which to assign this entry’s IP address.
Description Enter a description to help identify this static DHCP entry. You can use alphanumeric
and ()+/:=?!*#@$_%- characters, and it can be up to 60 characters long.
MAC Address
Setting
This section appears when Interface Type is external. Have the interface use either
the factory assigned default MAC address, a manually specified MAC address, or clone
the MAC address of another device or computer.
Use Default MAC
Address
Select this option to have the interface use the factory assigned default MAC address.
By default, the UAG uses the factory assigned MAC address to identify itself.
Overwrite
Default MAC
Address
Select this option to have the interface use a different MAC address. Either enter the
MAC address in the fields or click Clone by host and enter the IP address of the device
or computer whose MAC you are cloning. Once it is successfully configured, the address
will be copied to the configuration file. It will not change unless you change the setting
or upload a different configuration file.
Related Setting
Configure
PPPoE/PPTP
Click PPPoE/PPTP if this interface’s Internet connection uses PPPoE or PPTP.
OK Click OK to save your changes back to the UAG.
Cancel Click Cancel to exit this screen without saving.
Table 51 Configuration > Network > Interface > Ethernet > Edit (continued)
LABEL DESCRIPTION