Chapter 23 IPnP
UAG4100 User’s Guide
218
23.2 IPnP Screen
This screen allows you to enable IPnP on the UAG and specific internal interface(s). To access this
screen click Configuration > Network > IPnP.
Figure 144 Configuration > Network > IPnP
The following table describes the labels in this screen.
Table 100 Configuration > Network > IPnP
LABEL DESCRIPTION
Enable IPnP Select this option to turn on the IPnP feature on the UAG.
Note: You can enable this feature only when the firewall is enabled.
Member List The Available list displays the name(s) of the internal interface(s) on which you can
enable IPnP.
To enable IPnP on an interface, you can double-click a single entry to move it or use the
[Shift] or [Ctrl] key to select multiple entriess and click the right arrow button to add to the
Member list. To remove an interface, select the name(s) in the Member list and click the
left arrow button.
Apply Click Apply to save your changes back to the UAG.
Reset Click Reset to return the screen to its last-saved settings.
To Next Page
Loading...
