ZyXEL Communications UAG4100 - Policy Route Edit Screen

Chapter 12 Policy and Static Routes
UAG4100 User’s Guide
164
12.2.1 Policy Route Edit Screen
Click Configuration > Network > Routing to open the Policy Route screen. Then click the Add
or Edit icon in the Configuration section. The Add Policy Route or Policy Route Edit screen
opens. Use this screen to configure or edit a policy route.
DSCP Marking This is how the UAG handles the DSCP value of the outgoing packets that match this route.
If this field displays a DSCP value, the UAG applies that DSCP value to the route’s outgoing
packets.
preserve means the UAG does not modify the DSCP value of the route’s outgoing packets.
default means the UAG sets the DSCP value of the route’s outgoing packets to 0.
The “af” choices stand for Assured Forwarding. The number following the “af” identifies one
of four classes and one of three drop preferences. See Assured Forwarding (AF) PHB for
DiffServ on page 169 for more details.
SNAT This is the source IP address that the route uses.
It displays none if the UAG does not perform NAT for this route.
Apply Click Apply to save your changes back to the UAG.
Reset Click Reset to return the screen to its last-saved settings.
Table 72 Configuration > Network > Routing > Policy Route (continued)
LABEL DESCRIPTION