Chapter 21 IP/MAC Binding
UAG4100 User’s Guide
211
21.2.2 Static DHCP Edit
Click Configuration > Network > IP/MAC Binding > Edit to open the IP/MAC Binding Edit
screen. Click the Add or Edit icon to open the following screen. Use this screen to configure an
interface’s IP to MAC address binding settings.
Figure 137 Configuration > Network > IP/MAC Binding > Edit > Add
The following table describes the labels in this screen.
21.3 IP/MAC Binding Exempt List
Click Configuration > Network > IP/MAC Binding > Exempt List to open the IP/MAC
Binding Exempt List screen. Use this screen to configure ranges of IP addresses to which the UAG
does not apply IP/MAC binding.
Figure 138 Configuration > Network > IP/MAC Binding > Exempt List
Table 95 Configuration > Network > IP/MAC Binding > Edit > Add
LABEL DESCRIPTION
Interface Name This field displays the name of the interface within the UAG and the interface’s IP address
and subnet mask.
IP Address Enter the IP address that the UAG is to assign to a device with the entry’s MAC address.
MAC Address Enter the MAC address of the device to which the UAG assigns the entry’s IP address.
Description Enter up to 64 printable ASCII characters to help identify the entry. For example, you
may want to list the computer’s owner.
OK Click OK to save your changes back to the UAG.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
