ZyXEL Communications UAG4100 - SNMP Traps; Configuring SNMP

Chapter 40 System
UAG4100 User’s Guide
400
40.11.2 SNMP Traps
The UAG will send traps to the SNMP manager when any one of the following events occurs.
40.11.3 Configuring SNMP
To change your UAG’s SNMP settings, click Configuration > System > SNMP tab. The screen
appears as shown. Use this screen to configure your SNMP settings, including from which zones
SNMP can be used to access the UAG. You can also specify from which IP addresses the access can
come.
Figure 281 Configuration > System > SNMP
Table 193 SNMP Traps
OBJECT LABEL OBJECT ID DESCRIPTION
Cold Start 1.3.6.1.6.3.1.1.5.1 This trap is sent when the UAG is turned on or an agent
restarts.
linkDown 1.3.6.1.6.3.1.1.5.3 This trap is sent when the Ethernet link is down.
linkUp 1.3.6.1.6.3.1.1.5.4 This trap is sent when the Ethernet link is up.
authenticationFailure 1.3.6.1.6.3.1.1.5.5 This trap is sent when an SNMP request comes from non-
authenticated hosts.