Chapter 12 Policy and Static Routes
UAG4100 User’s Guide
168
The following table describes the labels in this screen.
12.3.1 Static Route Add/Edit Screen
Select a static route index number and click Add or Edit. The screen shown next appears. Use this
screen to configure the required information for a static route.
Figure 101 Configuration > Network > Routing > Static Route > Add
The following table describes the labels in this screen.
Table 74 Configuration > Network > Routing > Static Route
LABEL DESCRIPTION
Add Click this to create a new static route.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify the
entry’s settings.
Remove To remove an entry, select it and click Remove. The UAG confirms you want to remove it
before doing so.
# This is the number of an individual static route.
Destination This is the destination IP address.
Subnet Mask This is the IP subnet mask.
Next-Hop This is the IP address of the next-hop gateway or the interface through which the traffic is
routed. The gateway is a router or switch on the same segment as your UAG's interface(s).
The gateway helps forward packets to their destinations.
Metric This is the route’s priority among the UAG’s routes. The smaller the number, the higher
priority the route has.
Table 75 Configuration > Network > Routing > Static Route > Add
LABEL DESCRIPTION
Destination IP This parameter specifies the IP network address of the final destination. Routing is always
based on network number.
If you need to specify a route to a single host, enter the specific IP address here and use a
subnet mask of 255.255.255.255 (for IPv4) in the Subnet Mask field to force the network
number to be identical to the host ID.
Subnet Mask Enter the IP subnet mask here.
Gateway IP Select the radio button and enter the IP address of the next-hop gateway. The gateway is a
router or switch on the same segment as your UAG's interface(s). The gateway helps
forward packets to their destinations.
Interface Select the radio button and a predefined interface through which the traffic is sent.
To Next Page
Loading...
