Chapter 13 Zones
UAG4100 User’s Guide
172
The following table describes the labels in this screen.
13.2.1 Zone Edit
The Zone Edit screen allows you to add or edit a zone. To access this screen, go to the Zone
screen (see Section 13.2 on page 171), and click the Add icon or an Edit icon.
Figure 104 Network > Zone > Add
Table 77 Configuration > Network > Zone
LABEL DESCRIPTION
User
Configuration /
System Default
The UAG comes with pre-configured System Default zones that you cannot delete. You
can create your own User Configuration zones
Add Click this to create a new, user-configured zone.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify the
entry’s settings.
Remove To remove a user-configured trunk, select it and click Remove. The UAG confirms you
want to remove it before doing so.
Object Reference Select an entry and click Object Reference to open a screen that shows which settings
use the entry. See Section 10.3.2 on page 123 for an example.
# This field is a sequential value, and it is not associated with any interface.
Name This field displays the name of the zone.
Member This field displays the names of the interfaces that belong to each zone.
To Next Page
Loading...
