Chapter 18 SMTP Redirect
UAG4100 User’s Guide
198
Figure 122 Network > SMTP Redirect > Edit
The following table describes the labels in this screen.
Table 90 Network > SMTP Redirect > Edit
LABEL DESCRIPTION
Enable Use this option to turn the SMTP redirect rule on or off.
User Use the drop-down list box to select the individual user or user group for which you want
to use this rule.
Select any to have the SMTP redirect rule apply to all of the SMTP messages that the
UAG receives from any user.
Incoming Interface Select the interface on which the SMTP traffic must be received for the UAG to forward it
to the specified SMTP server.
Source Address Select the source address or address group for whom this rule applies. Use Create new
Object if you need to configure a new one. Select any if the rule is effective for every
source.
SMTP Server Enter the IP address of the SMTP server.
OK Click OK to save your changes back to the UAG.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
