Chapter 24 Web Authentication
UAG4100 User’s Guide
229
24.2.2.3 Set Up User Authentication Using the RADIUS Server
This step sets up user authentication using the RADIUS server. First, configure the settings for the
RADIUS server. Then, set up the authentication method, and configure the UAG to use the
authentication method. Finally, force users to log into the UAG before it routes traffic for them.
1 Click Configuration > Object > AAA Server > RADIUS. Double-click the radius entry.
Configure the RADIUS server’s address, authentication port (1812 if you were not told otherwise),
and key. Click OK.
Figure 152 Configuration > Object > AAA Server > RADIUS > Add
2 Click Configuration > Object > Auth. Method. Double-click the default entry. Click the Add
icon. Select group radius because the UAG should use the specified RADIUS server for
authentication. Click OK.
To Next Page
Loading...
