ZyXEL Communications UAG4100 - Page 26

Chapter 1 Introduction
UAG4100 User’s Guide
26
Wireless
Controller Configuration Configure how the UAG handles APs that newly connect to the
network.
AP
Management
Mgnt. AP List Edit wireless AP information, remove APs, and reboot them.
Network
Interface Port Role Use this screen to set the UAG’s flexible ports as LAN1 or LAN2.
Ethernet Manage Ethernet interfaces and virtual Ethernet interfaces.
PPP Create and manage PPPoE and PPTP interfaces.
VLAN Create and manage VLAN interfaces and virtual VLAN interfaces.
Bridge Create and manage bridges and virtual bridge interfaces.
Trunk Create and manage trunks (groups of interfaces) for load
balancing.
Routing Policy Route Create and manage routing policies.
Static Route Create and manage IP static routing information.
Zone Configure zones used to define various policies.
DDNS Define and manage the UAG’s DDNS domain names.
NAT Set up and manage port forwarding rules.
VPN 1-1
Mapping
General Enable and configure VPN 1-1 mapping to assign a public IP
address to each of users that match the rules.
Profile Configure a pool profile which defines the public IP address that the
UAG assigns to the matched users and the interface through which
the user’s traffic is forwarded.
HTTP Redirect Set up and manage HTTP redirection rules.
SMTP Redirect Set up and manage SMTP redirection rules.
ALG Configure SIP, H.323, and FTP pass-through settings.
UPnP enable UPnP and NAT-PMP on your UAG.
IP/MAC
Binding
Summary Configure IP to MAC address bindings for devices connected to
each supported interface.
Exempt List Configure ranges of IP addresses to which the UAG does not apply
IP/MAC binding.
Layer 2
Isolation
General Enable layer-2 isolation on the UAG and the internal interface(s).
White List Enable and configure the white list.
IPnP Enable IPnP on the UAG and the internal interface(s).
Web
Authentication
Web Authentication Define rules to force user authentication for network access.
Walled Garden Create walled garden links that display in the login screen.
Adverstisement Enable and set advertisement links.
Firewall Firewall Create and manage level-3 traffic rules.
Session Limit Limit the number of concurrent client NAT/firewall sessions.
Billing General Configure the general billing settings, such as the accounting
method.
Table 6 Configuration Menu Screens Summary (continued)
FOLDER OR LINK TAB FUNCTION