Chapter 7 Monitor
ZyWALL USG Series User’s Guide
219
7.14 Ethernet Neighbor Screen
The Ethernet Neighbor screen allows you to view the Zyxel Device’s neighboring devices in one place.
It uses Smart Connect, that is Link Layer Discovery Protocol (LLDP) for discovering and configuring LLDP-
aware devices in the same broadcast domain as the Zyxel Device that you’re logged into using the
web configurator.
LLDP is a layer-2 protocol that allows a network device to advertise its identity and capabilities on the
local network. It also allows the device to maintain and store information from adjacent devices which
are directly connected to the network device. This helps you discover network changes and perform
necessary network reconfiguration and management.
Note: Enable Smart Connect in the System > ZON screen.
See also System > ZON for more information on the Zyxel One Network (ZON) utility that uses the Zyxel
Discovery Protocol (ZDP) for discovering and configuring ZDP-aware Zyxel devices in the same network
as the computer on which the ZON utility is installed.
Click Monitor > System Status > Ethernet Neighbor to see the following screen
Figure 181 Monitor > System Status > Ethernet Neighbor
Status Ready - you can have the Zyxel Device use the USB storage device.
Click Remove Now to stop the Zyxel Device from using the USB storage device so you
can remove it.
Unused - the connected USB storage device was manually unmounted by using the
Remove Now button or for some reason the Zyxel Device cannot mount it.
Click Use It to have the Zyxel Device mount a connected USB storage device. This
button is grayed out if the file system is not supported (unknown) by the Zyxel Device.
none - no USB storage device is connected.
Detail This field displays any other information the Zyxel Device retrieves from the USB storage
device.
• Deactivated - the use of a USB storage device is disabled (turned off) on the Zyxel
Device.
• OutofSpace - the available disk space is less than the disk space full threshold.
• Mounting - the Zyxel Device is mounting the USB storage device.
• Removing - the Zyxel Device is unmounting the USB storage device.
• none - the USB device is operating normally or not connected.
Table 51 Monitor > System Status > USB Storage (continued)
LABEL DESCRIPTION
To Next Page
Loading...
