Chapter 17 IP/MAC Binding
ZyWALL USG Series User’s Guide
476
Interfaces Used With IP/MAC Binding
IP/MAC address bindings are grouped by interface. You can use IP/MAC binding with Ethernet, bridge,
VLAN, and WLAN interfaces. You can also enable or disable IP/MAC binding and logging in an
interface’s configuration screen.
17.2 IP/MAC Binding Summary
Click Configuration > Network > IP/MAC Binding to open the IP/MAC Binding Summary screen. This
screen lists the total number of IP to MAC address bindings for devices connected to each supported
interface.
Figure 339 Configuration > Network > IP/MAC Binding > Summary
The following table describes the labels in this screen.
17.2.1 IP/MAC Binding Edit
Click Configuration > Network > IP/MAC Binding > Edit to open the IP/MAC Binding Edit screen. Use this
screen to configure an interface’s IP to MAC address binding settings.
Table 160 Configuration > Network > IP/MAC Binding > Summary
LABEL DESCRIPTION
Edit Double-click an entry or select it and click Edit to open a screen where you can modify the
entry’s settings.
Activate To turn on an entry, select it and click Activate.
Inactivate To turn off an entry, select it and click Inactivate.
# This field is a sequential value, and it is not associated with a specific entry.
Status This icon is lit when the entry is active and dimmed when the entry is inactive.
Interface This is the name of an interface that supports IP/MAC binding.
Number of
Binding
This field displays the interface’s total number of IP/MAC bindings and IP addresses that the
interface has assigned by DHCP.
Apply Click Apply to save your changes back to the Zyxel Device.
To Next Page
Loading...
