Chapter 7 Monitor
ZyWALL USG Series User’s Guide
228
7.17 AP Information: Radio List
Click Monitor > Wireless > AP Information > Radio List to display the Radio List screen.
Figure 186 Monitor > Wireless > AP Information > Radio List
Radio 1/2 OP Mode Select the operating mode for radio 1 or radio 2.
AP Mode means the AP can receive connections from wireless clients and pass their data
traffic through to the Zyxel Device to be managed (or subsequently passed on to an
upstream gateway for managing).
MON Mode means the AP monitors the broadcast area for other APs, then passes their
information on to the Zyxel Device where it can be determined if those APs are friendly or
rogue. If an AP is set to this mode it cannot receive connections from wireless clients.
Radio 1/2 Profile Select a profile from the list. If no profile exists, you can create a new one through the
Create new Object menu.
Override Group
Output Power
Setting
Select this option to overwrite the AP output power setting with the setting you configure
here.
Output Power Set the output power of the AP.
Override Group SSID
Setting
Select this option to overwrite the AP SSID profile setting with the setting you configure here.
This section allows you to associate an SSID profile with the radio.
Edit Select an SSID and click this button to reassign it. The selected SSID becomes editable
immediately upon clicking.
# This is the index number of the SSID profile. You can associate up to eight SSID profiles with
an AP radio.
SSID Profile Indicates which SSID profile is associated with this radio profile.
Force Overwrite
VLAN Config
Select this to have the Zyxel Device change the AP’s management VLAN to match the
configuration in this screen.
Management VLAN
ID
Enter a VLAN ID for this AP.
As Native VLAN Select this option to treat this VLAN ID as a VLAN created on the Zyxel Device and not one
assigned to it from outside the network.
OK Click OK to save your changes back to the Zyxel Device.
Cancel Click Cancel to close the window with changes unsaved.
Table 57 Monitor > Wireless > AP Information > AP List > Config AP (continued)
LABEL DESCRIPTION
To Next Page
Loading...
