Chapter 46 File Manager
ZyWALL USG Series User’s Guide
991
46.3.3 The Firmware Management Screen
Click Maintenance > File Manager > Firmware Management to open the Firmware Management screen.
Figure 703 Maintenance > File Manager > Firmware Management
The following table describes the labels in this screen.
Table 401 Maintenance > File Manager > Firmware Management
LABEL DESCRIPTION
Firmware Status
Reboot Click the Reboot icon to restart the Zyxel Device. If you applied changes in the Web
configurator, these were saved automatically and do not change when you reboot. If you
made changes in the CLI, however, you have to use the write command to save the
configuration before you reboot. Otherwise, the changes are lost when you reboot.
If you want the Standby firmware to be the Running firmware, then select the Standby
firmware row and click Reboot. Wait a few minutes until the login screen appears. If the login
screen does not appear, clear your browser cache and refresh the screen or type the IP
address of the Zyxel Device in your Web browser again.
You can also use the CLI command reboot to restart the Zyxel Device.
# This displays the system space (partition) index number where the firmware is located. The
firmware can be either Standby or Running; only one firmware can be running at any one
time.
Status This indicates whether the firmware is Running, or not running but already uploaded to the
Zyxel Device and is on Standby. It displays N/A if there is no firmware uploaded to that system
space.
Model This is the model name of the device which the firmware is running on.
To Next Page
Loading...
