Chapter 29 Object
USG20(W)-VPN Series User’s Guide
496
The following table describes the labels in this screen. See Section 29.6.3.1 on page 496 for more
information as well.
29.6.3.1 The Service Group Add/Edit Screen
The Service Group Add/Edit screen allows you to create a new service group or edit an existing
one. To access this screen, go to the Service Group screen (see Section 29.6.3 on page 495), and
click either the Add icon or an Edit icon.
Figure 335 Configuration > Object > Service > Service Group > Edit
Table 205 Configuration > Object > Service > Service Group
LABEL DESCRIPTION
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to be able to modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The USG confirms you want to remove it
before doing so.
Object
References
Select an entry and click Object References to open a screen that shows which settings
use the entry.
# This field is a sequential value, and it is not associated with a specific service group.
Family This field displays the Server Group supported type, which is according to your
configurations in the Service Group Add/Edit screen.
There are 3 types of families:
• : Supports IPv4 only
• : Supports IPv6 only
• : Supports both IPv4 and IPv6
Name This field displays the name of each service group.
By default, the USG uses services starting with “Default_Allow_” in the security policies to
allow certain services to connect to the USG.
Description This field displays the description of each service group, if any.
Reference This displays the number of times an object reference is used in a profile.
To Next Page
Loading...
