Pannoramic MIDI 1.17 User’s Guide 5 Troubleshooting and Maintenance
• When the HXP 120 illumination unit is switched on:
◦ NEVER look directly into the fiber-optic cable.
◦ NEVER remove the fiber-optic cable from the device.
◦ NEVER connect the fiber-optic cable to the device.
◦ NEVER remove the housing from the device.
5.1.1 Cleaning the device
• Before cleaning, switch off the device and pull the plug out.
• Do not let liquid penetrate into the system.
• To clean liquid from the device, use a lint-free cotton cloth. You can moisten the cloth with
water.
• To clean greasy surfaces, it is recommended to apply Isopropanol or Ethanol on a piece of
lint-free cotton cloth and gently rub the surface.
5.1.2 Cleaning the trays
NEVER clean the trays with Xylene, because it might harm the plastic. We recommend to apply
Isopropanol or Ethanol on a piece of lint-free cotton cloth and gently rub the surface instead. In case
the tray is damaged, use either order a new one, as inserting a deteriorated tray could lead into
unsafe loading of slides.
5.1.3 Preventive maintenance
To prevent fungus growth
• Do not leave the equipment in an unconditioned environment with a storage temperature
above 60°C (140°F) or below 0°C (32°F), which may damage the equipment.
• Maximum operating temperature is 35°C (95°F) with a relative humidity of less than 75%.
• Install it in a room with proper air ventilation.
• Do not let dust or fingerprints remain on optical surfaces.
April 3, 2014 - Rev. 1 3DHISTECH Ltd.
108(127)
To Next Page
Loading...
Need help?
General
