page 9
A10 Thunder Series 6430(S) ADC/CGN
Rack-Mount Kit Installation
This chapter contains instructions for installing the rack-mount kit for the A10 Thunder Series 6430(S)
device.
The following topics are covered:
• Getting Started
• Rack-Mount Installation
Getting Started
This section describes how to use the rack-mount kit to install the A10 Thunder Series 6430(S) into an
equipment rack.
Rack-Mount Contents
The rack-mount kit contains the following items. Verify that all parts are included and are not damaged.
• Two adjustable rail sets (Figure 5).
Each set consists of one inner rail and two end brackets.
• 22 pan-head screws, for attaching inner rails to chassis
• 13 M5 hex nuts and 13 x pan-screws, for attaching rail assemblies to rack
To Next Page
Loading...
