page 3
A10 Thunder Series 6430(S) ADC/CGN
Getting Started
This guide describes how to physically install the A10 Thunder 6430(S) ADC/CGN models, how to con-
figure the MGMT (management) interface for network access to the Command-Line Interface (CLI),
and how to configure the Lights Out Management (LOM) interface for remote access to specific sys-
tem-level commands.
FIGURE 1 Thunder 6430 (Front Panel View)
FIGURE 2 Thunder 6430 (Rear Panel View)
Inspection
Inspect the box carefully before opening it. If the box is damaged, contact the shipper for instructions
on filing a claim. Opening a damaged box before inspection by the shipper will void any potential ship-
ping claims.
To Next Page
Loading...
