A10 Thunder Series User Manual

A10 Thunder Series 6430(S) ADC/CGN
Power Supply Hot Swap
page 34
Removing a Power Supply
To remove a power supply:
1. Push and hold the panel to unlock the lock (A).
2. Hold the panel and pull out the power supply
Inserting a Power Supply
Before inserting the new power supply on any A10 Thunder Series device, be sure to remove the power
supply bottom gasket (see Figure 29
).
FIGURE 29 Power Supply Bottom Gasket
To insert the new power supply:
1. Push the power supply into the slot.
2. Plug the AC or DC power cable into the power supply.

A10 Thunder Series Specifications

General

Model	A10 Thunder Series
Category	Network Hardware
Application Delivery	Yes
Advanced Load Balancing	Yes
SSL Insight	Yes
DDoS Protection	Yes
IPv6 Migration	Yes
Hardware Acceleration	Yes
Humidity	5% to 95% non-condensing
Operating Temperature	32°F to 104°F (0°C to 40°C)
Interfaces	10/100/1000/10G/40G/100G Ethernet
Power Supply	Redundant Power Supplies Available