A10 Thunder Series - Page 46

A10 Thunder Series 6430(S) ADC/CGN
Port Splitting Configuration Examples
page 44
ACOS(config)# no system-4x10g-mode enable
This command will modify your system to enable 4x10g-mode support.
Any configurations on the affected interface(s) and interface references
from VLANs/Trunks/Routing etc. are advised to be removed first,
otherwise the interface configurations may cause errors and/or be lost.
The mode change will take effect starting from the next reboot.
Please confirm to proceed:
Do you want to proceed with the 4x10g-mode command now (N/Y)? : y
This command will require you to save the running configuration
to startup configuration MANUALLY.
Please confirm you will save the configuration to proceed:
Will you save the running-configuration MANUALLY (N/Y)? : y
Please reboot the system when you are ready...
ACOS(config)# end
ACOS# write memory
Building configuration...
Write configuration to profile "splitter_disabled"
ACOS# reboot
Proceed with reboot? [yes/no]: yes
Message from syslogd@localhost at Dec 8 17:16:29 ...
a10logd: [SYSTEM]<0> System is going to reboot. Reason: Scheduled reboot.