107
Peripheral devices
AD-8920A： Remote Display
□ This option can be connected to the balance using the RS-232C interface or current loop and
displays the weighing data transmitted by the balance.
AD-8922A： Remote Controller
□ This option can be connected to the balance using the RS-232C interface and can control the
balance remotely.
AD-8127： Compact printer
□ Small dot impact printer that connects with the balance via the RS-232C interface.
□ Statistical function, clock and calendar function, interval print function, graphic print function, dump
print mode
AD-1687： Weighing Environment logger
□ A data logger equipped with 4 sensors for temperature, humidity, barometric pressure and
vibration that can measure and store environmental data. When connected to the RS-232C
interface of the balance, the AD-1687 can store environmental data along with weighing data.
Therefore, it is possible to store data in an environment where a computer can not be used.
□
The stored data can be read to a personal computer using USB. As the AD-1687 is recognized as USB
memory, special software is not required to read the data.
AD-1688： Data Logger
□ When connected to the RS-232C interface of the balance, the AD-1688 can store the data in an
environment where a personal computer can not be used.
AD-1689： Tweezers for calibration weight
□ A pair of tweezers ideally suited for holding calibration weights of 1g to 500g.
AX-USP-9P： USB Converter
□ An RS-232C cable is provided to connect the USB converter to the balance.
□ Enables bi-directional communication between the PC and the balance when a USB driver is
installed.
AX-SW137-PRINT： Foot switch for print (with connector)
□ Foot switch that functions in the same way as the PRINT key when combined with GXA-23 external
connector
AX-SW137-REZERO： Foot switch for re-zero (with connector)
□ Foot switch that functions in the same way as the RE-ZERO key when combined with GXA-23
external connector
To Next Page
Loading...
