A&D GF-2002A - Storing Units

17
4-2 Storing Units
The units or modes can be selected and stored in the function table. The sequence of displaying the units
or modes can be arranged to fit the frequency of use.
The units stored are maintained in non-volatile memory, even if the AC adapter is removed.
Select a unit or mode and arrange the sequence of display as follows:
1 Press and hold the SAMPLE key until ba5fnc of the
function table is displayed, then release the key.
2 Press the SAMPLE key several times to display 1Unit .
3 Press the PRINT key to enter the unit selection mode.
4 Specify a unit or mode in the order to be displayed using
the following keys.
SAMPLE key To sequentially display the units.
RE-ZERO key To specify a unit or mode. The
stabilization indicator
appears when the displayed unit or
mode is specified.
If the key is pressed in units already
selected, the stability mark disappears.
5 Press the PRINT key to store the units or modes. The
balance displays end and then displays the next menu of
the function table.
6 Press the CAL key to exit the function table. Then the balance
returns to the weighing mode with the selected unit.
7 To select other unit or mode for weighing, press the MODE key.
Press
several times
Select
Specify
Store
Displays the units
sequentially.
Press and hold