13
Key operation
Key operation affects how the balance functions. The basic key operations are:
“Press and release the key immediately” or “Press the key”
= normal key operation during measurement
“Press and hold the key”
Key When pressed When pressed and held
Turns the display ON:OFF. The standby indicator is displayed when the display is
turned off. The weighing mode is enabled when the display is turned on.
When password function is enable, password input display will be displayed. Refer to
"20-3 Inputting Password Lock When Turning On The Balance"
This ON:OFF key is available anytime. Pressing the ON:OFF key during operation
will interrupt operation and turn the display OFF.
In the weighing mode, turns the minimum
weighing value on and off.
In the counting or percent mode, enters the
sample storing mode.
Enters the function table mode.
Switches the weighing units stored in the
function table.
（
、 、 、 、 ）
Displays other items of the calibration
menu.
Performs calibration of the balance using
the internal mass.
Displays other items of the calibration
menu.
Stores the weighing data in memory or
outputs to a printer or personal computer
depending on the function table settings.
(Factory setting = output)
Enters mode to change the unit mass
registration number in counting mode.
By changing the function table:
・ Outputs "Title block" and "End
block" for GLP,GMP report.
・ Displays the data memory menu.
・ Enters mode for reading density
number in flow measurement.
Sets the display to zero.
Press and hold the key.
Press the key.
(Press and release the key immediately.)
To Next Page
Loading...
