A&D GF-2002A - Page 45

43
Parameter
0
1
0
1
Accepts the PRINT key only when
the display is stable.
Auto print mode B
（Reference=last stable value）
Cp beep
bep HH
bep Hi
bep lo
bep ll
Data output mode
Key mode
Auto print mode A
（Reference=zero）
Stream mode
Key mode B (Immediately)
2
3
4
5
6
Interval output mode
Outputs data for each time
set by
int .
2
2
Plus only
Minus only
Biolarity
10 digit
100 digit
1000 digit
Regardless of displayed value
Auto print polarity
Auto print difference
Data output
Class Item Description
HH buzzer
OFF
ON
0
1
prt
Comparator
buzzer
Difference between reference
value and displayed value
Displayed only when 5 step
comparator is set.
Displayed only when 5 step
comparator is set.
Note: "Digit" is a unit of minimum weighing value.
Factory setting
Outputs data when the weighing value
stabilizes beyond the range form
ap-p
to
ap-b
from the zero point.
Outputs data when the weighig
value stabilizes beyond the range
from
ap-p
to
ap-b
from last stable
value.
Outputs data at the specified
display refresh rate.
Accepts the PRINT key
regardless of the display
condition.
Accepts the PRINT key
immediately when the display is
stable, or waits for the display to
be stable when not.
0
1
0
1
0
1
OFF
ON
OFF
ON
OFF
ON
0
1
OFF
ON
HI buzzer
OK buzzer
LO buzzer
LL buzzer
0
1
ap-p
ap-b
dout
Key mode C (When stable)