49
Display refresh rate ( 5pd )
The periodic time to refresh the display. This parameter influences "Baud rate", "Data output pause"
and the data output rate of "Stream mode".
Decimal point ( pnt )
The decimal point format can be selected.
Auto display-ON ( p-on )
When the AC adapter is plugged in, the display is automatically turned on without the ON:OFF
key operation, to display the weighing mode. Used when the balance is built into an automated system.
One hour warm up is necessary for accurate weighing.
Auto power-OFF（p-off）
This is a function to turn off only the display automatically when there is no operation made for a
certain amount of time (approximately 10 minutes) while the power is on.
Minimum display（ ）
When weighing with rough precision, the minimum display can be turned off without key
operation. This is useful when built into an automated system/
Buzzer（beep）
Select ON/OFF for the built-in buzzer that sounds when a key is operated or the status changes.
Tare value record（ ）
After turning on the power supply, the display will not be automatically set to zero, and it will start
from the previous weighing value. This is useful when a hopper, etc. is attached to the weighing pan
and the power needs to be turned off while weighing discharge.
Backlight brightness（ ）
Select the brightness of the backlight of the LCD display.
Bubble sprit level lightning（ ）
Select ON/OFF for the LED that illuminates the bubble sprit level.
To Next Page
Loading...
