Installation
108
Aastra 415/430 as of R3.2
syd-0344/1.6 – R3.2 – 09.2014
Tab. 41 Connection of BRI-S basic rate interface external, networked with copper line
Bus configuration
BRI-S ext. is subject to the conditions that apply to terminal interface BRI-S (see "BRI-
S terminal interfaces", page 121).
Fig. 34 Basic rate interface BRI-T, networked with leased-line or dial-up connection
Tab. 42 Cabling for basic rate interface BRI-T, networked with leased-line or dial-up connection
See also
Chapter "Connections with basic accesses" in the PISN/QSIG Networking
System Manual.
4. 7. 2. 2 Primary rate interface PRI
With the appropriate interface cards and Wiring Adapters, PRI network interfaces
can be made available at RJ45 sockets 1.1, 2.1, 3.1 and 4.1 (Aastra 415 only 1.1, 2.1).
For test purposes the PRI interface is also routed in parallel to ports x.2. The possi-
ble RJ45 sockets are highlighted in colour in the figure below.
PINX 1 signal
BRI-S basic rate interface ext.
Cable cores
PINX 2 signal
Basic rate interface BRI-T
cc
ff
ee
dd
PINX1 signal,
basic rate inter-
face BRI-T
Cable cores NT1 Network NT1 Cable cores
PINX 2 signal,
basic rate inter-
face BRI-T
ccc c
fff f
eee e
ddd d
To Next Page
Loading...
