Expansion Stages and System Capacity
55
Aastra 415/430 as of R3.2
syd-0344/1.6 – R3.2 – 09.2014
Tab. 27 Wiring Adapter
The assignment to the RJ45 sockets depending on the Wiring Adapters is shown in
Tab. 36.
3. 4 System capacity
System capacities are defined on the one hand by the existing hardware with its ex-
pansion possibilities and on the other by the limits set in the software. The software
limits can be partly expandable by licences.
3. 4. 1 General system capacity
The number of slots, interface cards and system modules per communication
server have already been mentioned in the previous chapters and are not listed
separately in this chapter.
Tab. 28 General system capacity
Type Use with... Remarks
WA-TS0 TIC-4TS, TIC-2TS, ESST
1)
1)
On the ESST terminal card the jumper must always be fitted in position T (see Fig. 24).
Included in the equipment supplied with
TIC-4TS and TIC-2TS
WA-TS1 TIC-4TS, TIC-2TS, ESST
1)
, ODAB Included in the equipment supplied with
ODAB
WA-2W Mainboard interfaces, TIC-4AB, TIC-2AB,
ETAB4, EAAB2, EADP4, EAD4C, EAD4V
Included in the equipment supplied with
TIC-4AB, TIC-2AB, ETAB4 and EADP4 (with
ETAB4 and EADP4 only with order variant
Aastra 415/430).
WA-1PRI TIC-1PRI Included in the equipment supplied with
TIC-1PRI
Max. number... Aastra 415 Aastra 430
AIN with
Aastra 430 as
Master
Nodes in a transparent network (AIN) – – 11
Nodes with SIP networking 100 100 –
Users 12
1)
50
2)
50
2)
Terminals per user
3)
16 16 16
Simultaneous connections
• Without IP and without DECT (internal / external) 10
4)
30 50
• IP – not IP (internal / external) 8 18 50
• IP – IP (internal) 6
4)
25
4)
50
• IP – IP via SIP access channels (external) 16 32 32
• DECT – not DECT (internal / external) 10
4)
20 per node
To Next Page
Loading...
