Installation
148
Aastra 415/430 as of R3.2
syd-0344/1.6 – R3.2 – 09.2014
User allocation
In the configuration each terminal is assigned to a user or a free seating pool. If a
terminal has been created at the connected port and the address selection switch
is correctly selected but no user or free seating pool is allocated to the terminal, the
system phone display reads No Number and indicates the terminal ID. In this state
the system phone is not ready for operation.
Terminal type
The terminal type is specified along with the configuration of the system. Lines are
also assigned to the line keys there.
Note:
If the terminal type configured is incorrect, the system phone display
shows the warning Wrong phone type. On the Office 10 the LED flashes
slowly. In this situation, although the system phone can be used for basic
telephone operations, none of the added features will be available. The
terminal type must be entered via WebAdmin or on the terminal via login
to the system configuration.
Carrying out a logon on the system phone:
– Office 10: : Press the Foxkey twice.
– All other system phones: Long keypress (long click) on a function key.
Set new phone type appears next. Confirm with Foxkey Yes.
4. 8. 1. 2 Aastra 5360/5361/5370/5380
These IP system phones can be both desktop-mounted and wall-mounted.
Mounting the phone
The following points are described in detail in the User’s Guides for Aastra 5360/
5361/5370/5380:
• Set-up as a desk phone (choice of two different set-up angles)
•Wall mounting
• Connecting one or more Aastra M530 or Aastra M535 expansion key modules.
• Connection of a headset to DHSG standard.
To Next Page
Loading...
