Expansion Stages and System Capacity
76
Aastra 415/430 as of R3.2
syd-0344/1.6 – R3.2 – 09.2014
All the licences are offered in separate licence packages. Depending on the sales
channels the packages may differ from the licences in Tab. 31. The systems ship out
unlicensed. Back-licensing is not provided for. However, resetting to the factory set-
ting is possible.
OIP licences
OIP licences are managed by OIP itself. A detailed description of the OIP licences
can be found in the System Manual Open Interfaces Platform.
3. 4. 5 Power supply capacity
The maximum number of terminals connected to the system can be limited by the
supply power available for terminals. It is also important to take note of the maxi-
mum load per terminal interface.
3. 4. 5. 1 Supply power available for terminals
The 40 VDC power supply required for the connected terminals is rated for the
power requirements of a typical system configuration.
Tab. 32 Power output of the 40 VDC power supply
Presence Sync. via
SIMPLE and MSRP
Number of users who
can use one (or both)
protocols for the third-
party applications.
0 1, 20 or 50 additional
users per licence who
may use both proto-
cols.
In the AIN,
only on the
Master;
otherwise
per node.
✓✓
SMPP
4)
SMPP protocol unavaila-
ble
enabled In the AIN,
only on the
Master;
otherwise
per node.
––
1)
The licence (as well as the temporary/definite activation tool) is not available in each sales channel.
2)
4 hours after the new software has been uploaded, the communication server switches over to a restricted
operating mode (see "Restricted operating mode", page 69).
3)
If VoIP mode is set to G.711, two G.711 VoIP channels per system can be used without a licence.
4)
This licence cannot be purchased separately; it is part of the licence. Advanced Messaging
Aastra 415 Aastra 430
Available power output 24 Watt 24 Watt
Licence Licensed attributes
Without
licence
With licence
Licences
for net-
working
Offlin
e
licenc
e
Trial
licenc
e
To Next Page
Loading...
