Installation
98
Aastra 415/430 as of R3.2
syd-0344/1.6 – R3.2 – 09.2014
4. 5. 2 Wiring Adapter
Wiring adapters are used to route the interfaces of the interface cards to the RJ45
sockets on the front panel and are fitted to slots WA1…WA4. The WA0 slot is never
equipped. Slots WA3 and WA4 are to be found only on the Aastra 430 (see also
Fig. 7).
The table below provides an overview of the combinations of wiring adapters and
interface cards. Unless specified otherwise, the corresponding wiring adapter is in-
cluded in the equipment supplied with each interface card.
Tab. 36 Combinations of wiring adapters / interface cards
Wiring Adapter Interface card
Plug-in ori-
entation
Port number
X.1 X.2 X.3 X.4
WA-TS0 TIC-4TS TTTT T T T T
TIC-4TS STTT S T T T
TIC-2TS TTTT T T – –
TIC-2TS STTT S T – –
ESST
1)2)
1)
The wiring adapter is not part of the equipment supplied with this interface card and must be ordered sepa-
rately.
2)
On the ESST terminal card the jumper must always be fitted in position T (see Fig. 24).
STTT S T – –
WA-TS1 TIC-4TS
1)
SSTT S S T T
TIC-4TS
1)
SSST S S S T
TIC-2TS
1)
SSTT S S – –
TIC-2TS
1)
SSST S S – –
ESST
1)2)
SSTT S S – –
ESST
1)2)
SSST S S – –
ODAB SSTT I/O 1,2 I/O 3,4 ab/Door
Intercom
–
WA-2W ETAB4
3)
3)
The wiring adapter is only part of the equipment supplied with order variant Aastra 415/430.
– FXS FXS FXS FXS
EADP4
3)
– DSI DSI DSI DSI
EAD4C
1)
– DSI DSI DSI DSI
EAD4V
1)
– DSI DSI DSI DSI
EAAB2
1)
–––FXOFXO
TIC-4AB – FXO FXO FXO FXO
TIC-2AB – FXO FXO – –
WA-1PRI TIC-1PRI – PRI Test
4)
4)
For test purposes the PRI interface is also routed in parallel to port X.2.
––
To Next Page
Loading...
