Installation
97
Aastra 415/430 as of R3.2
syd-0344/1.6 – R3.2 – 09.2014
2. Remove the housing cover.
3. Place the interface card at a slight angle into the required slot (see Fig. 23). Make
sure the angled side of the interface card is facing backwards (i.e. it must not
project over the wiring adapter slots).
4. Carefully press the interface card downwards until the two lateral metal clamps
engage.
5. Fit the corresponding wiring adapter (see "Wiring Adapter", page 98) into the ap-
propriate wiring adapter slot WA1…WA4.
6. Fit the housing cover.
7. Reconnect the communication server to the power supply.
Fig. 23 Fitting an interface card
Notes
– The ODAB options card must be fitted to slot IC2 (Aastra 415) or slot
IC4 (Aastra 430) if it is to be used for connecting a door intercom (see
"Equipment on the ODAB options card", page 138).
– The interface cards EAD4V and EAD4C cannot be fitted to slot IC4 of an
Aastra 430 due to their mechanical dimensions.
To Next Page
Loading...
