Installation
147
Aastra 415/430 as of R3.2
syd-0344/1.6 – R3.2 – 09.2014
4. 8 Installing, powering and connecting terminals
4. 8. 1 Digital system phones
4. 8. 1. 1 General information
Accesses
The connections on the underside of the system phones are identified by the sym-
bols. The meaning of the symbols is described in the corresponding operating in-
structions.
DSI terminal interface
Tab. 76 DSI interface on the phone
Note:
The total length of the cables from the communication server to the sys-
tem phone must not be less than 10 m.
Terminal selection
Two system phones can be connected to a DSI interface (DSI-AD2 only). The system
can only differentiate the two system phones by the position of the address switch
on the phone. The following settings are possible (TSD = Terminal Selection Digit):
•TSD1
•TSD2
Note:
In the following cases Not Configured is displayed along with the node
number, the slot number and the port number. In this state the system
phone is not ready for operation:
– A terminal has been created at the connected port, but the address
selection switch is incorrectly set.
– No terminal has yet been created at the connected port.
RJ45 socket Pin Signal
1—
2—
3b
4a
5—
6—
To Next Page
Loading...
