Installation
90
Aastra 415/430 as of R3.2
syd-0344/1.6 – R3.2 – 09.2014
Note
The fan only turns if required by the equipment temperature.
Fig. 17 Installing the fan in Aastra 430
4. 2. 7. 3 Installing the cable cover
Materials required:
• Cable cover set for Aastra 415/430
• Screwdriver
To install the cable cover proceed as follows:
1. Pull off the screw covers on the left and right of the front panel.
2. Use the M4 screws of the cable cover set to secure the brackets for the cable
cover to the communication server.
Note
The two brackets are not identical. Compare the cable brackets with
the figures in Fig. 18.
3. Fit the cable cover over the brackets from above until they are felt to engage.
To Next Page
Loading...
