Installation
113
Aastra 415/430 as of R3.2
syd-0344/1.6 – R3.2 – 09.2014
power failure the EFOP switches exchange lines automatically and
directly over to up to 8 analogue phones (see "Emergency fan-out-panel
(EFOP)", page 131).
In a direct connection the RJ45 connector is connected directly to the trunk cable
using a crimp clip.
With an indirection connection you need to observe the cable requirements.
Note
Circuit type as per EN/IEC 60950: TNV-3
Connection
Assignment of the RJ45 sockets on the front panel:
Tab. 48 Connection FXO network interface
Cable Requirements
Tab. 49 Cable requirements for FXO network interface
Public analogue network
Communication server
FXO signal Pin Socket
–1
–2
–3
a4
b5
–6
–7
–8
Core pairs cores 1 2
Stranded not required
Wire diameter, core 0.4 … 0.8 mm
Screening not required
Resistance max. 2 250
To Next Page
Loading...
