EasyManua.ls Logo

Aastra 415 - Using Functions While in a Call

Aastra 415
270 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Expansion Stages and System Capacity
46
Aastra 415/430 as of R3.2
syd-0344/1.6 – R3.2 – 09.2014
Use of VoIP channels
VoIP channels are always required between IP and non-IP endpoints. They are
freely available, i.e. they are always used wherever they happen to be needed. The
figure below gives an overview of the cases where VoIP channels are needed and
how many of them
Tab. 18 Required VoIP channels between two possible endpoints
Non-IP endpoints:
Analogue terminal (FXS)
Digital system terminal (DSI)
DECT cordless phone (DSI)
ISDN phone (BRI-S)
External via analogue exchange (FXO)
External via ISDN exchange (BRI-T/PRI)
Internal voice mail system
•Auto attendant
Internal announcement service
•Music on hold
Conversation recording
Queue with announcement
IP endpoints
IP system phone
Aastra SIP terminal
Standard SIP terminal
DECT cordless phone via SIP-DECT
WiFi cordless phone via SIP-DECT
WiFi cordless phone via SIP access point
WiFi mobile phone via AMC controller
External via SIP provider
IP endpoints on satellites:
In normal operation all IP endpoints are registered with
the master, even if they are located on the satellite.
Master
Satellit
IP endpoint
IP endpoint
Non-IP endpoint
Non-IP endpoint
Non-IP endpoint
Non-IP endpoint
Direct switching: No VoIP channel
Indirect switching: 2 VoIP channels
2 VoIP channels
No VoIP channel
No VoIP channel
1 VoIP channel
1 VoIP channel

Table of Contents

Other manuals for Aastra 415

Related product manuals