To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...
What to do if ABB Transmitter detects an overpressure?
If the ABB Transmitter detects an overpressure because the measured process pressure value is outside the sensor limits and no longer represents the true applied process value, adjust the working range if possible.
What to do if ABB 2600T shows a pressure overrange?
If the ABB Transmitter indicates a pressure overrange because the measured static pressure is above its operational limit, adjust the working range if possible.
How to execute replacement operation on ABB 2600T after changing electronics or sensor?
If the electronics or the sensor of your ABB Transmitter have been changed but the replacement operation has not been executed, you must perform the following steps: 1. Move the SW 1 of the electronics to position 1 to enable replace mode. 2. Select the SW 2 to indicate whether the new element is a new sensor or new electronics. 3. Power cycle the device. 4. Move the SW 1 of the electronics to position 0.
What to do if ABB Transmitter sensor temperature is out of operational limits?
If the ABB Transmitter's measured sensor temperature is outside of its operational limits, check the valves and impulse line. If necessary, clean the impulse line and initiate PILD training.
What happens if ABB Transmitter device data is corrupted at start up?
If the device data loaded at the start up of your ABB Transmitter are corrupted, precluding the correct functionality of the device because of exchange of data problems between Electronics and Sensor, the device will continue to work without problems, but at the next power cycle the new configuration will be lost.
General| Output Signal | 4-20 mA HART, Fieldbus |
|---|---|
| Response Time | < 100 ms |
| Process Temperature | -40 to 120 °C (-40 to 248 °F) (depending on model and fill fluid) |
| Ambient Temperature | -40 to 85 °C (-40 to 185 °F) |
| Power Supply | 10.5 to 42 V DC (depending on communication protocol and options) |
| Housing Material | Aluminum or stainless steel |
| Material | Stainless steel, Hastelloy |
| Protection Class | IP66, IP67 |
| Hazardous Area Approvals | ATEX, IECEx, FM, CSA |
| Process Connection | 1/2" NPT, 1/4" NPT |
| Electrical Connection | 1/2" NPT, M20 |
| Operating Temperature | -40 to 85 °C (-40 to 185 °F) |
| Communication Protocol | HART, PROFIBUS PA, FOUNDATION Fieldbus |
