ABB 2600T Series Operating Instructions

sym Error HMI code Description Possible Cause Suggested Actions
Primary Variable Out of Range S050.010 Process value is outside its working range The measured pressure value is beyond its Low or High scaling limits
Adjust the working range if possible.
Static Pressure Out of Range S048.011 Static Pressure is outside its working range The Measured Static Pressure is beyond its Low or high scaling limits
Adjust the working range if possible.
PILD Output
Both Impulse Lines Plugged
M018.038
PILD algorithm has detected both impulse lines plugged.
Both connections between the pressure sensor and the process are blocked either by plugging or closed valves.
Check valves and impulse line. Clean impulse line if necessary and initiate PILD training
Impulse Line on High Side Plugged
PILD algorithm has detected a plugged impulse line on the HIGH side.
The connection between the pressure sensor and the process on the HIGH side is blocked either by plugging or closed valves.
Impulse Line on Low Side Plugged
PILD algorithm has detected a plugged impulse line on the LOW side.
The connection between the pressure sensor and the process on the LOW side is blocked either by plugging or closed valves
One Undefined impulse line plugged
PILD algorithm has detected one plugged impulse line.
One of the connections between the pressure sensor and the process is blocked either by plugging or closed valves.
PILD Changed Operating Conditions M016.039
The pressure value currently detected is too different from what used for the PILD Training
Process conditions have changed to an extent that new settings for the PILD algorithm are needed.
A new Training is necessary for this new process condition

ABB 2600T Series Specifications

General

Brand	ABB
Model	2600T Series
Category	Transmitter
Language	English