ABB ACS320 - Actual signals and parameters

Actual signals and parameters 143
11
Actual signals and
parameters
Contents of this chapter
The chapter describes the actual signals and parameters and gives the fieldbus
equivalent values for each signal/parameter. It also contains a table of the default
values for the different macros.
Note: When the control panel is in the short parameter view, in other words, when
parameter 1611 PARAMETER VIEW is set to 2 (SHORT VIEW), the control panel
only shows a subset of all signals and parameters. The list of these signals and
parameters starts on page 144.
To be able to view all actual signals and parameters, set parameter 1611
PARAMETER VIEW to 3 (LONG VIEW). The descriptions of parameters start on
pages 148.