ABB ACS355 - Page 254

254 Actual signals and parameters
inH2O inches of water 58
in wg inches of water gauge 59
ft wg feet on water gauge 60
lbsi pounds per squared inch 61
ms millisecond 62
Mrev millions of revolutions 63
ddays 64
inWC inches of water column 65
m/min meters per minute 66
Nm Newton meter 67
Km3/h thousand cubic meters per hour 68
%ref reference in percentage 117
%act actual value in percentage 118
%dev deviation in percentage 119
% LD load in percentage 120
% SP set point in percentage 121
%FBK feedback in percentage 122
Iout output current (in percentage) 123
Vout output voltage 124
Fout output frequency 125
Tout output torque 126
Vdc DC voltage 127
3406 OUTPUT1 MIN Sets the minimum display value for the signal selected by
parameter 3401 SIGNAL1 PARAM. See parameter 3402
SIGNAL1 MIN.
Note: Parameter is not effective if parameter 3404
OUTPUT1 DSP FORM setting is DIRECT.
-
x…x Setting range depends on parameter 3401 setting. -
3407 OUTPUT1
MAX
Sets the maximum display value for the signal selected by
parameter 3401 SIGNAL1 PARAM. See parameter 3402
SIGNAL1 MIN.
Note: Parameter is not effective if parameter 3404
OUTPUT1 DSP FORM setting is DIRECT.
-
x…x Setting range depends on parameter 3401 setting. -
3408 SIGNAL2
PARAM
Selects the second signal to be displayed on the control
panel in the Output mode. See parameter 3401 SIGNAL1
PARAM.
104
0= NOT
SELECTED
101…180
Parameter index in group 01 OPERATING DATA. Eg 102 =
0102 SPEED. If value is set to 0, no signal is selected.
1 = 1
All parameters
No. Name/Value Description Def/FbEq