Figure 6-2 Grounding the drive and the motor (multi-point
bonding) 94
Figure 6-3 Grounding the drive and the motor (single-point
bonding) 95
Figure 6-4 PE ground busbar in COU (back view) 96
Figure 6-5 PE ground busbar in PCU (back view) 96
Figure 6-6 Wiring across shipping splits, frame size 1 (A)
and 2 (B) 99
Figure 6-7 Wiring across shipping splits, frame size 3 and 4 100
Figure 6-8 Cable entry with sealing modules – type 1 101
Figure 6-9 Cable entry frame sizes (top) for type 1 sealing
modules (bottom) 102
Figure 6-10 Cable entry with sealing modules – type 1 103
Figure 6-11 Cable entry with cable gland 103
Figure 6-12 Cable entry with EMC plates 104
Figure 6-13 Preparing power cables for cable glands 106
Figure 6-14 Preparing power cables for sealing modules 107
Figure 6-15 PCU cable terminals, top and bottom entry (back
view) 109
Figure 6-16 COU cable terminals, top and bottom entry (back
view) - frame sizes 1 and 2 (A) and 3 and
4 (B) 110
Figure 6-17 Bolted busbar connection 111
Figure 6-18 Preparing control cables for EMC plates 113
Figure 6-19 Preparing control cables for sealing modules 114
Figure 6-20 Preparing control cables for cable glands 115
Figure 6-21 Cable routing in WCU800 (A) and WCU1400 (B)
cabinets 116
Figure 6-22 Shield grounding clamp 117
Figure 6-23 COU customer interface section 117
To Next Page
Loading...
