Note: For frame R8: Install the side plates if removed.
Note: For frame R8: The power cable connectors can be detached. For the
instructions, see section R8 power cable connection if you detach the cable
connectors (page 100).
10. For frame R6 types bigger than -040A-x: Cut tabs in the shroud for the installed
cables.
11. Install the shroud onto the power cable connection terminals.
R8 power cable connection if you detach the cable connectors
The power cable connectors of frame R8 are detachable. If you detach them, you can
connect the cables with cable lugs as follows:
• Remove the nut that attaches the connector to the terminal post and remove the
connector.
• Alternative 1: Put the conductor to the connector. Tighten to a torque of 30 N·m. Put
the connector back onto the post. Tighten the connector to 30 N·m.
• Alternative 2: Attach a cable lug to the conductor. Put the cable lug onto the post.
Tighten the nut to a torque of 30 N·m.
100 Electrical installation – IEC
To Next Page
Loading...
