Applicable standards
The drive complies with the following standards. The compliance with the European
Low Voltage Directive is verified according to standard EN 61800-5-1.
Safety of machinery. Electrical equipment of machines. Part 1: General
requirements. Provisions for compliance: The final assembler of the
machine is responsible for installing
EN 60204-1:2006 +
AI:2009 + AC:2010
- emergency-stop device
- supply disconnecting device.
Degrees of protection provided by enclosures (IP code)
IEC/EN 60529:1981
+A1:1999 + A2: 2013
Electromagnetic compatibility (EMC) – Limits for harmonic
IEC 61000-3-2:2018,
EN 61000-3-2:2014
current emissions (input current < 16 A per phase)
Electromagnetic compatibility (EMC) - Part 3-12: Limits - Limits for har-
monic currents produced by equipment connected to public low-voltage
systems with input current > 16 A and < 75 A per phase.
IEC/EN 61000-3-
12:2011
Limits - Limitation of emission of harmonic currents in low-voltage power
supply systems for equipment with rated current greater than 16 A
IEC 61000-3-4:1998
Adjustable speed electrical power drive systems. Part 3: EMC require-
ments and specific test methods
IEC/EN 61800-3:2004
+ A1:2012
Adjustable speed electrical power drive systems. Part 5-1: Safety require-
ments – electrical, thermal and energy
IEC/EN 61800-5-
1:2007
Adjustable speed electrical power drive systems – Part 9-2: Ecodesign
for power drive systems, motor starters, power electronics and their
driven applications – Energy efficiency indicators for power drive systems
and motor starters
IEC 61800-9-2: 2017
Insulation coordination for equipment within low-voltage systems. Part
1: Principles, requirements and tests.
IEC/EN 60664-1:2007
Standard for Adjustable Speed Electrical Power Drive Systems - Part
5-1: Safety Requirements - Electrical, Thermal and Energy
UL 61800-5-1: First
edition 2012
Enclosures for Electrical Equipment (1000 Volts Maximum)
NEMA 250:2014
Industrial control equipment
CSA C22.2 No. 274-17
Ambient conditions
Environmental limits for the drive are given below. The drive is to be used in a heated,
indoor, controlled environment. All printed circuit boards are conformal coated.
TransportationStorageOperation
in the protective pack-
age
in the protective pack-
age
installed for stationary
use
Technical data 193
To Next Page
Loading...
