Installing option modules
￭ Mechanical installation of option modules
See section Overview of power and control connections (page 32) for the available slots
for each module. Install the option modules as follows:
WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or death,
or damage to the equipment can occur.
1.
Stop the drive and do the steps in section Electrical safety precautions (page 15)
before you start the work.
2. Remove the front cover(s) if not already removed.
3. For frame R3: Pull the control panel holder up.
4. Insert the module carefully into its position on the control unit.
5. Tighten the mounting screw torque of 0.8 N·m.
Electrical installation – IEC 105
To Next Page
Loading...
