Installing the drive vertically
1. Mark the hole locations using the mounting template included in the package. Do
not leave the mounting template under the drive. The drive dimensions and hole
locations are also shown in the dimension drawings.
2. Drill the mounting holes.
3. Insert anchors or plugs into the holes and start the screws or bolts into the anchors
or plugs. Drive the screws or bolts long enough into the wall to make them carry
the weight of the drive.
4. Position the drive onto the bolts on the wall.
5. For R6 and R8 with option +B056 (UL Type 12): Install the hood on top of the drive
before you tighten the upper fastening bolts. Place the vertical edge of the hood in
between the wall and the drive back plate.
6. Tighten the bolts in the wall securely.
Mechanical installation 49
To Next Page
Loading...
