ABB ACS880-11 - Page 7

64Power cable types ........................................................................................
64Preferred power cable types .............................................................
65Alternate power cable types .............................................................
66Not allowed power cable types .........................................................
67Additional guidelines, North America ...........................................................
67Metal conduit ....................................................................................
68Power cable shield .......................................................................................
68Selecting the control cables ................................................................................
68Shielding ......................................................................................................
69Signals in separate cables ...........................................................................
69Signals that can be run in the same cable ...................................................
69Relay cable ..................................................................................................
69Control panel to drive cable .........................................................................
69PC tool cable ................................................................................................
69Routing the cables ..............................................................................................
69General guidelines – IEC .............................................................................
70General guidelines – North America ............................................................
71
Continuous motor cable shield/conduit or enclosure for equipment on the
motor cable ..................................................................................................
72Separate control cable ducts .......................................................................
72DC voltage boost function ...................................................................................
72
Protecting the drive, input power cable, motor and motor cable in short circuit
situations and against thermal overload .............................................................
72Protecting the drive and the input power cable in short-circuits ...................
73Circuit breakers ............................................................................................
73Protecting the motor and motor cable in short-circuits .................................
73Protecting the motor cables against thermal overload .................................
74Protecting the motor against thermal overload ............................................
74
Protecting the motor against overload without thermal model or temperature
sensors .........................................................................................................
75Implementing a motor temperature sensor connection ......................................
76Connecting motor temperature sensor to the drive via an option module ....
76Protecting the drive against ground faults ..........................................................
76Residual current device compatibility ...........................................................
77Implementing the emergency stop function ........................................................
77Implementing the Safe torque off function ..........................................................
77Implementing the power loss ride-through function ............................................
78Implementing the functions provided by the FSO-xx safety functions module ....
78Using power factor compensation capacitors with the drive ...............................
79Using a safety switch between the drive and the motor .....................................
79Implementing an ATEX-certified motor thermal protection .................................
79Controlling a contactor between drive and motor ...............................................
80Implementing a bypass connection ....................................................................
80Protecting the contacts of relay outputs ..............................................................
Table of contents 7